Kana Dynamic IP Updater

Latest version: 3.1.0.15, beta version: 3.2.0.17

Dialer does not work

Question:

I am using cable modem to connect to the internet, so I set Kana Dynamic IP Updater to use LAN in connection setting. I also setup the dialer, and tell Kana Dynamic IP Updater to dial if no connection is available. But when my cable modem is disconnected, the dialer does not work. What is the problem?

Answer:

Dialer only works if you select to use modem as connection to the internet. Kana Dynamic IP Updater uses internal method to detect the connection, and it only works when modem is selected. Although it is possible to use PING to detect connection, so it will work with LAN or Proxy, that method is not implemented.

Dial-up connection

When you select the dial-up in connection settings, you will see the Dialer tab from where you can enter your dial-up account configuration .

  • Email this page
  • Print this page
  • A  A  A

Post a Comment

Leave your comment below
The comment is moderated. Only comments related to the post will be accepted.
Your name
Email address
Your comment

Read Comments No comment yet Comment feed

No comments yet.
  • Back to top
  • Last updated: Friday, November 12, 2010 11:49 am
Printed:
Beta
You can get this information from:
http://www.kanasolution.com/products/dyndns-updater/dyndns-faqs/dialer-does-not-work/
Close this window
Email This Information
To send the message, please fill the form below
Email To
Subject
Message
Your Email
Validation

Please enter the text on the following image in the verification box below. Click here if you cannot read the text. All alphabets are in upper case.

Verification image